4 noise, 5 abnormal wear on plastic parts, 4 noise 13.5 abnormal wear on plastic parts – FlexLink WL322 (322 мм) Монтаж User Manual
Page 42
Troubleshooting
38
5683EN-1
13.4
Noise
13.5
Abnormal wear on plastic parts
Cause
Corrective action
Worn or damaged bear-
ings in drive unit
Check/replace drive unit.
Damaged/badly fitted slide
rail
Check the free running of the conveyor
belt, especially in slide rail joints.
Excessive conveyor speed Lower speed.
Check actual load against recommended
loading.
Incorrect conveyor belt
tension
Lengthen/shorten conveyor belt.
Cause
Corrective action
Overloaded conveyor
Remove products from conveyor
and test run.
Check the free running of the con-
veyor belt.
Check actual conveyor load
against recommended loading.
Ambient temperature too high
Check against recommended
temperature for conveyor.
Chemicals in the environment are
affecting plastic parts
Check in FlexLink main catalogue
(section TR) for listing of incom-
patible chemicals.
Damage due to ingress of con-
taminate
Clean the system.
Particles, swarf etc.
Remove source of contamination.