Burkert Type 0789 - Manual (Page 6)

6
GeneralSafetyInstructions
2.3. special instructions in explosion-risk
areas
WarnInG!
danger caused by electrostatic charge!
If there is a sudden discharge from electrostatically charged devices
or persons, there is a danger of explosion in the explosion-risk area.
• Take appropriate measures to prevent electrostatic charges in
explosion-risk areas.
• Clean the device surface by gently wiping it with a damp or
antistatic cloth only.
Additional special conditions can be found under “5.1” of
these operating instructions.
3. general safeTy insTrucTiOns
These safety instructions do not take into account
• any contingencies or events which may occur during the installation,
operation and maintenance of the devices.
• local safety regulations, the observance of which is the responsibility
of the operator, also with respect to the installation personnel.
danger of explosion!
• The device is a sealed system. It must not be opened
danger of electrostatic charge!
Acute risk of injury from hazardous structure-borne voltage!
Risk of damage to the device due to short circuit!
• Before starting work, switch off the power supply and secure to
prevent it being switched on again!
• Observe the applicable accident prevention and safety regula-
tions for electrical devices!
danger - high pressure!
• There is a serious risk of injury when reaching into the
equipment.
• Before loosening the lines and valves, turn off the pressure and
vent the lines.
• Observe the currently valid accident prevention and safety
regulations!
english
PTB 03 ATEX 1030 X