Burkert Type 8793 - Manual (Page 31)

31
Electrical Installation
Type 8792, 8793
Pin Configuration
On the
device side External circuit/ Signal
level
Output signals to the control centre (e.g. PLC) - (only used for
analog output option)
8
(red)*
Analogue
feedback + 8 + (0/4 ... 20 mA or 0 ... 5 /
10 V)
completely galvanically
isolated
7 (blue)*
Analogue
feedback GND 7 GND Analogue feedback
Operating voltage
3
(green)* GND 3
4
24 V DC ± 10 %
max. residual ripple10
%
4
(yellow)* +24 V
* The wire colours indicated in brackets refer to the connection cable, part
no. 919061, available as an accessory.
Tab. 8: Pin assignment; X1 - M12, 8-pole circular connector
14.3.2 X4 - M8, 4-pole socket (for binary
outputs option only)
Output signals to the control centre
(e.g. PLC)
Pin Configuration
On the
device side External circuit /
Signal level
1 Binary output 1 1 0 ... 24 V
2 Binary output 2 2 0 ... 24 V
3 Binary output GND 3
GND (identical
with the GND
operating voltage)
Tab. 9: Pin assignment; X4 - M8, 4-pole socket - output signals to the
control centre
When the operating voltage is applied, the positioner is operating.
→
Now make the required basic settings and actuate the automatic
adjustment of the positioner. The procedure is described in chapter
“16.2 Starting-up Type 8792”.
english