Burkert Type 8041 - Manual (Page 46)

44
Adjustmentandcommissioning
→
Release the push button when desired number
of LEDs is on.
to set the units for the low switching threshold.
→
Briefly press push button
After 2 s, next LED flashes;
1 flash = 1 % of the FS
If low switching threshold set to 24%, LED no. 3
flashes 9 times then stays on;
1 flash = 1 % of the FS
Next LEDS come on one after the other until they
show the factor of ten for the current high switching
threshold;
1 LED ON = 10 % of the FS
A
If high switching threshold set to 82%, LED no. 9
flashes 9 times then stays on;
1 flash = 1 % of the FS
Next LEDS come on one after the other until they
show the factor of ten for the current low switching
threshold;
1 LED ON = 10 % of the FS
→
Release the push button when desired number of
LEDs is on.
to set the units for the high switching threshold.
→
Briefly press push button
After 2 s, next LED flashes;
1 flash = 1 % of the FS
→
Release push button when LED has flashed the desired
number of times
B
C
Fig. 42: Setting the relay switching thresholds, part 2
English
Type 8041