Fluid Components International ST51 - Manual (Page 37)

ST51 MASS FLOW FLUID COMPONENTS INTERNATIONAL LLC
This page is subject to proprietary rights statement on last page 37 Doc. No. 06EN003389 Rev. -
Fax Cover Sheet
Company: ___________________________________ Date: ______________________________________
Attention: ___________________________________ Dept: ______________________________________
Fax No: _____________________________________ Direct Phone: _______________________________
From: ______________________________________ No. of Pages: _______________________________
To expedite repairs the following Return Authorization Request form must be completed and faxed
back to FCI before a Return Authorization Number will be is-
sued. The Decontamination Statement must be signed and Ap-
plicable MSDS Sheets must be included with the shipment.
FCI will either fax or telephone you with the Return Authorization
Number upon receipt of the completed form.
Packing Procedures
1. Electronics should be wrapped in an anti-static or static-
resistant bag (FCI can provide), then wrapped in protective
bubble wrap and surrounded with appropriate dunnage* in a
box. Instruments weighing up to 50 lbs., should be wrapped
in protective wrap and surrounded with appropriate dunnage*
in a box. Instruments weighing more than 50 lbs., or ex-
tending more than four feet should be secured in wooden
crates by bolting the assemblies in place.
2. The sensor element must be protected with tubing or other
sturdy wrapping or, when applicable, retracted completely and
secured into the Packing Gland Assembly. FCI will supply
suitable probe protectors at your request (see diagram - right).
3. FCI can supply crates at a nominal fee.
4. No more than four (4) small units packaged in each carton.
5. Packages weighing in excess of 70 lbs., or with the com-
bined length and girth of more than 138” cannot be shipped
via UPS and should be shipped via carriers who specialize in
the transport of industrialized instrumentation.
6. FCI will not be held liable for damage caused during shipping.
7. To ensure immediate processing mark the RA number on the outside of the box. Items without
an RA number marked on the box or crate may be delayed.
8. Freight Must be “PrePaid” to FCI receiving door.
Factory Return Shipping Address: Fluid Components International LLC
1755 La Costa Meadows Drive
San Marcos, CA 92078-5115
Attn: Repair Department,
RA #____________
* Approriate dunnage as defined by UPS, will protect package contents from a drop of 3 feet.
This message is intended for the use of the individual or entity to whom it is addressed and may contain proprietary data or
confidential business or financial information that can only be used, copied, or disclosed as authorized by Fluid Components.
PVC
Probe protector
Anti-Static Bag
Visit FCI on the Worldwide Web: w ww.fluidcomponents.com
1755 La Costa Meadows Drive, San Marcos, California 92078 USA ‡ Phone: 760-744-6950 ‡ 800-854-1993 ‡ Fax: 760-736-6250