Alliance Laundry Systems Extractors P232156R9 - Manual (Page 38)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Basic Installation/Operation
F232156 36
UW Models with P-Control
Pre-Operating Instructions
1. Turn on the main power source (circuit breaker or
cut-off switch on wall). Models with the rotation
sensor will display WE-6 Firmware ID Code
“
HRWC18 ” and later (i.e., “ HRWC19 ”) after
power up. For models without rotation sensor,
proceed to step 1 of Operating Instructions.
2. Display shows size of machine and will flash
“TEST?” and “SPEED” for 15 seconds.
3. Push Start keypad during the 15 seconds.
Machine will test rotation sensing for 15 seconds.
4. Display will flash “POWER” and “WAIT” one
time and will display “NEXT00.”
NOTE: If START keypad is not pushed while
display flashes “TEST?” and “SPEED” or if
rotation sensing fails, then display flashes
“POWER” and “WAIT” before showing
“NEXT00” for approximately 2 minutes.
Operating Instructions
1. When display shows “NEXT00,” washer-
extractor is ready to be loaded with laundry.
2. On UW35 – UW125 models, use left hand to
press and hold the door unlock button located on
the lower right front of the control panel. Refer to
Figure 21.
Figure 21
3. On UW35 – UW125 models, use right hand to
turn door handle clockwise and swing the door
left to open. Refer to Figure 22.
Figure 22
MD003J
UW35 – UW125 MODELS
MD004J
Do not operate machine in a cycle with
program keymode switch in program
position. Program keymode switch must
be in run position at all times, except
when editing or programming cycle or
setup information.
W528
WARNING
UW35 – UW125 MODELS