Hydrotech 6700 XTR Valve Downflow Automatic Water Softeners Service Manual - Manual (Page 12)

Page 12
Master Programming Mode
CAUTION: Before entering Master Programming, please contact your local professional water dealer.
When the Master Programming Mode is entered, parameters can be set to make the timer function as needed.
NOTE: Depending on current option settings, some displays cannot be viewed or set.
Entering Master Programming Mode:
1. Press and hold the Shift and Up buttons for 5 seconds.
OR
2. Set the time of day display to 12:01 PM or 12:01HR (See the User Programming section to.
learn how to set the Time of Day). Then go to the main display screen, press the Up and Down.
buttons at the same time for 5 seconds.
Exiting Master Programming Mode:
1. Press the Extra Cycle button once per display until all are viewed. Master Programming Mode is.
exited and the normal display screen appears.
2. To exit the Master Programming Mode without saving, press the Diagnostic button.
. NOTE: If no keypad activity is made for 5 minutes while in the Master Programming Mode, or if
there is a power failure, no changes will be made, and the unit will go back to the main display
screen.
Resets:
.
Soft Reset: Press and hold the Up and Down buttons for 25 seconds until 12:00PM (or 12:00HR).
appears. This resets all parameters except for the flow meter totalizer volume..
. Master Reset: Hold the Shift button while powering up the unit. This resets all of the.
parameters in the unit. Check and verify the choices selected in Master Programming Mode.
System Type
This program step selects the system type..
— Press the Up or Down buttons to adjust this value..
— Press the Extra Cycle button..
.
.
.
.
Valve Type
This program step selects the valve type..
— Press the Up or Down buttons to adjust this value..
— Press the Extra Cycle button..
.
.
.
.
1.
2.