Hydrotech 6700 XTR Valve Downflow Automatic Water Softeners Service Manual - Manual (Page 16)

Page 16
a. Timed Auxiliary Relay Output Window (Start & End Time Setting)
This option setting consists of two displays. The first display sets the turn-on time of the output, referenced
to the start of the first regeneration cycle. The second display sets the output turn-off time, referenced again
to the start of the first regeneration cycle. An OFF setting cancels this setting. All settings are in minutes and
output timing is synchronized with regeneration cycle timing..
.
. Start Time: Any time during regeneration..
. End Time: At start time, and anytime during the regeneration cycle..
.
.
.
.
..
b. Chemical Pump Auxiliary Relay Output Window
This option setting consists of two displays. The first display sets the volume of water flow at which the output
turns on. The second display sets the on time (in seconds) of the output..
— Activate output after volume set is reached..
— Press the Shift button to select the digit you want to modify..
— Press the Up or Down buttons to adjust this value..
— Press the Extra Cycle button..
.
.
.
.
Flow Meter Size
This program step sets the size of the flow meter.
.
— Press the Up or Down buttons to adjust this value..
— Press the Extra Cycle button..
.
.
.
.
Maximum Flow Rate
This program step sets maximum flow rate of the generic flow meter..
— Press the Shift button to select the digit you want to modify..
— Press the Up or Down buttons to adjust this value..
— Press the Extra Cycle button.
Pulses per Gallon/Liter
This program step sets the pulses per gallon/liter for generic flow meters..
— Press the Shift button to select the digit you want to modify..
— Press the Up or Down buttons to adjust this value..
— Press the Extra Cycle button.
End of Master Programming Mode
16.
17.
18.
19.
CAUTION: Before entering Master Programming, please contact your local professional water dealer.
Master Programming Mode