9 - coding the remote controls, Channels scheme, Off on – CAME Krono-S5D Kit User Manual
Page 17: Channel 1 channel 3, Channel 4 channel 2, Fig 17
16
2.9 - Coding the Remote Controls
T432S (MINI-PINK) Remotes
Remove the battery cover off of the remote and change the Factory set code to a unique code for the
installation via the 10 dipswitches.
Insert the frequency card into the control panel (item 5 on motherboard). Identify the little yellow button
on the motherboard and press and hold the little yellow button in and an LED will flash. Then press
the button on the remote control you wish to operate the equipment with and then let go of both
buttons. Make sure any additional remotes are the same code. You do not have to program these into
the board - they should work.
OFF
ON
1
3
MOTHERBOARD
"AF" BOARD
NS. -
- T.C.A. -
1
ON
2
3
4
5
6
7
8
9 10
Channel 1
Channel 3
Channels
selection
jumpers
Code selection
dipswitch:
set the same
code
programmed
on receiver
actionning LED
4 pins strip
1st key fixed
on channel 1
2nd key preset on
channel 2; put the
jumpers as shown in
figures to change
Channel 4
Channel 2
Channels Scheme
Fig 17