Install the sensor, Sensor installation options – Hach-Lange LDO Sensor User Manual
Page 8
After the sensor is attached, scan for the sensor. Refer to
on page 8.
Install the sensor
There are two options to install the sensor:
• Connect the sensor while power to the controller is off. The controller will look for and install new
sensors when it is turned on.
• Connect the sensor while power to the controller is on. Use the Scan Devices command to install
the new sensor:
Option
Description
sc200 controller
Go to MENU>TEST/MAINT>SCAN DEVICE
sc100 controller
Go to MENU>TEST/MAINT>SCAN SENSORS
sc1000 controller Go to MENU>SYSTEM SETUP>DEVICE MANAGEMENT>SCANNING FOR NEW
DEVICES
Connect the sensor in a non-hazardous location
on page 7 for digital sensor connection.
Sensor installation options
The installation and accessory options available for the LDO sensor are supplied with installation
instructions in the hardware kit.
shows several installation options. To order installation
hardware, refer to
Replacement parts and accessories
Figure 5 Installation options
1 Rail mount
4 Chain mount
2 Float mount
5 Union mount
3 Air blast system mount
8 English