Hach-Lange Filter probe sc - Manual (Page 17)

15
Installation
3.3.2 Installing filter module
Important note: Do not let the filter modules dry out, as dry filter
modules will become unusable immediately and cannot be
repaired.
Never touch the filter surface, as the filter surface will be destroyed
by the grease from the skin.
Never immerse the filtration probe in water without filter modules,
as unfiltered water could block the filtration probe.
1. Insert the filter module in the bottom.
2. Pivot the filter module towards the inside and press onto the
frame until it engages.
3. Proceed with the second filter module on the other side in the
same way.
Figure 4 Installation of the filter modules