Hach-Lange TSS EX1 sc - Manual (Page 16)

16
Operation
16
Operation
16
Operation
4.4 Menu structure
Note: Refer to Section 6 Malfunctions, causes, resolution for a list of all error and warning messages
as well as a description of all necessary corrective actions.
4.4.1 SENSOR STATUS
SELECT SENSOR (if there is more than one sensor)
ERRORS
Possible error messages: MEAS. OVERRANGE, CAL. INSUFF. +/–, ZERO, CAL REQUIRED,
EE RSRVD ERR, ERROR PROBE, LED FAILURE
WARNINGS Possible warning messages: TEST/MAINT
4.4.2 SENSOR setup
SELECT SENSOR (if there is more than one sensor)
WIPE Triggers a wiping operation
CALIBRATE (turbidity)
OUTPUT MODE Behavior of the outputs during calibration or while the zero point is being set
HOLD
ACTIVE
TRANSFER
SELECTION
SENS MEASURE Current, uncorrected measurement value
FACTOR Can be set from 0.10 to 10.00, a detailed description is provided in section 4.5 CALIBRATE
OFFSET Can be set from –100 to +100, a detailed description is provided in section 4.5 CALIBRATE
CALIBRATE
MEMORY
POINT 1 Calibration point 1 is recorded
POINT 2 Calibration point 2 is recorded
POINT 3 Calibration point 3 is recorded
CLEAR MEMORY Clears the recorded values for all points.
POINT 1 Current calibration for point 1
POINT 2 Current calibration for point 2
POINT 3 Current calibration for point 3
SET CAL DEFLT Security prompt, reset to default calibration
CALIBRATE (TS content)