Hach-Lange SONATAX sc - Manual (Page 11)

11
Section 3 Installation
The SONATAX sc can be used with an sc100, sc200 or with an
sc1000 controller. Installation instructions are found in the
handbook of the controller.
3.1 Unpack sensor
The SONATAX sc is supplied with the following components:
• Sensor
• User manual
• Wiper blades set (5 pieces)
If one of the parts is missing or damaged, please contact the
manufacturer or dealer.
3.1.1 Handling of the immersed probe
The immersed probe contains a sensitive ultrasound transducer.
Make sure that this is subjected to no hard mechanical impacts. Do
not install the probe hanging on the cable. Make sure before the
insertion of the probe into the medium that all functions run
undisrupted through a check of the system. Check the probe
carefully for external damage.
3.2 Connect sensor to an sc controller
3.2.1 Connect sensor with quick connection
The sensor cable is very easy to connect to the controller using a
quick connection (
Figure 4 ). Keep the protective cap of the
connection socket in case you remove the sensor later and must
seal the socket. For longer sensor cable lengths, optional extension
cables are available.
D A N G E R
The installation described in this section of the user manual should only
be performed by qualified and specialized personnel. The sensor is not
suitable for installation in hazardous areas.
Figure 4 Connect sensor with quick connection