Hach-Lange 2100Q and 2100Qis Basic User Manual - Manual (Page 16)

Error/Warning Description Solution
Please disconnect the
USB cable from your
computer. Data storage does not
respond while connected
to the meter and the
computer. Disconnect the USB
cable from the meter and
try sending data again.
USB module memory
full. Delete data and try
again. Data storage is full. 1. Connect USB/power
module to the computer.
2. Download the stored
data to the computer.
3. Delete Data Log on
the module.
Delete Last Reading
Failed! Error in the data storage. Turn the meter off and
on. If the error message
still occurs, contact
technical support.
Delete Data Log failed!
Can't read data set!
Can't store data!
Can't store to the
Reading Log!
Can't store to the Verify
Cal Log!
Error storing data!
Error reading data!
16 English