Laurel Electronics Custom ASCII Protocol For Laureate Series 2 Digital Panel Meters, Counters, Timers & L-Series Transmitters - Manual (Page 13)

13
Press Menu
Select Key Press Digit Select
Key Press Value Select
Key
00000U
RS485 half or full duplex
0 Full duplex
1 Half duplex
00000U
Special start & stop char.
(entered using Instrument
Setup Software)
0 * Start, <CR> Stop characters
1 Special Start & Stop characters
00000U
RTS mode (for RS232)
0 Normal non-latching RTS
1 Single transmission, latching RTS
00000U
Termination characters
0 Only at end of all items
1 At end of each item
00000U
Data sent, digital panel meter
only
0 Reading
1 Peak
2 Valley
3 Reading + Peak
4 Reading + Valley
5 Reading + Peak + Valley
. SEr 3 .
Serial Setup 3
00000U
Data sent, scale meter only
0 Net + Gross
1 Net only
2 Gross only
3 Peak only (Net or Gross)
4 Net + Gross + Peak
5 Valley only
__000U
Modbus ASCII gap timeout*
0 1 sec 2 5 sec
1 3 sec 3 10 sec
__000U
Serial protocol
0 Custom ASCII
1 Modbus RTU*
2 Modbus ASCII*
SEr 4 .
Serial Setup 4
__000U
Parity
0 None
1 Odd (Modbus only)*
2 Even (Modbus only)*
_ Addr
Modbus Address*
__000 __000 __000
Select digit to flash.
__158
Select 0 through 9 for flashing digit.
Address range is 1 to 247.
* Modbus is not applicable to our weight meter.