Magnum Venus Plastech High Duo Pro Gun - Manual (Page 13)

MAGNUM VENUS PLASTECH HIGH VOLUME DUO PRO GUN 13
HV Duo Pro Gun
Introduction
Generally, the HV Dual Pro Gun™ will not need to be completely disassembled for
daily cleaning. However, the entire gun should be disassembled and the o-rings and
seals replaced approximately every six months depending on use.
Disassembling the HV Dual Pro Gun™ is easy; the gun breaks down into two separate
modules which are then disassembled further into their individual parts. A special tool
kit (HVPG-TOOLS), which includes a specially designed HV Pro Gun™ tool and a
packing assembly tool, is available to aid in performing maintenance and repair.
Tools required
• You will need the following tools:
• Rubber mallet
• Thread Sealant
• Adjustable wrench
• Needle-nose pliers
• Flat-end screwdriver
• Lubriplate™ lubricant (08465)
• Scribe set (08126)
• Pro Gun™ oil (04394)
• Seal Installation tool (58198-1)
• HV Pro Gun™ packing bit (58199-1)
• You should also have appropriate cleaning materials such as solvent, clean
shop towels or rags, a small brush, and empty containers into which you will
flush the gun.
• Also, you will need new o-rings and seals to replace the current ones in the HV
Duo Pro Gun™. Please refer to the parts drawings to obtain proper parts
numbers for the o-rings and seals to be replaced.
Note: If you are using o-ring part number O-K-008 in the flush assembly, you do
not need to replace the o-ring unless it is showing obvious signs of wear. This
o-ring is specially designed to handle most solvents.
DANGER: To prevent accidental injection injury, disconnect all air and electrical
power to the unit before beginning repair or maintenance on this equipment.
CHAPTER
1