Magnum Venus Plastech High Duo Pro Gun - Manual (Page 21)

MAGNUM VENUS PLASTECH HIGH VOLUME DUO PRO GUN 21
Reassemble Resin/Hardener Components
1. Place the Hardener/Resin Seal components onto the Seal installation tool in
the following order:
• Packing ring (58146-1)
• Hardener/Resin seal (58126-1-GFT)
• Relief spacer (58123-1)
Note: The hole in the Seals should be aligned with the port hole in the Gun
block before inserting the Seal installation tool into the gun block.
2. Insert the seal installation tool with the components on it, into the catalyst side
of the gun block. Press firmly, or tap with a rubber mallet, then pull the
packing tool out of the gun block.
Note: Again before inserting the Seal installation tool, align the holes in the
Seals with the holes in the Gun block as closely as possible.
3. The Resin / Hardener Seal components should be seated in the interior of the
Gun block against the Center spacer.
4.
Check that the holes in the Seals are properly aligned with the holes in the
Gun block by looking through the ports in the Gun Block.
5. Gently screw a Packing nut (58122-1) into the Gun Block. Do not tighten.
Note: At this point, the Resin / Hardener Packing nuts should only be hand tight.
GUN BLOCK
PACKING RING
RESIN SEAL
RELIEF SPACER
SEAL INSTALLATION TOOL
RESIN SEAL
RELIEF SPACER
PACKING RING