Hv duo pro gun, Actuator assembly, Chapter – Magnum Venus Plastech High Duo Pro Gun User Manual
Page 26
MAGNUM VENUS PLASTECH HIGH VOLUME DUO PRO GUN
26
HV Duo Pro Gun
Actuator Assembly
Actuator Disassembly
1.
Remove the End cap from both ends of the Cylinder body.
2.
Push the Actuator Piston out the back of the Cylinder body.
3.
Replace the O-ring (O-V-133) on the Actuator piston.
4.
Check the Actuator bushing and Cylinder Body for wear or damage.
5.
Apply a light film of Pro Gun oil to both the inside of the Cylinder and Actuator piston.
6.
Install the Actuator Piston into the Cylinder body, the Actuator bushing should
go in first and be off center towards the top.
7.
Install the End cap onto both ends of the Cylinder body.
Assembly the Components
1.
Align the Actuator Stem on the Gun block with the Actuator bushing in the
Cylinder body.
2.
Attach the Gun block to the Cylinder using the four screws, seals.
CHAPTER
4