Mallory Ignition ACCEL DIS 8 75610 - Manual (Page 17)

DIS 8
17
Handheld Controller
The controller has a 9-pin DSUB socket which plugs into the on the end panel. The
controller does not need to be plugged in for the ignition to run, only to change the
settings. The control “modes’ are as listed below.
Setting Range / Resolution Action
Main RPML 1000-12800/100 RPM Set maximum RPM limit
Auxiliary RPML 1000-12800/100 RPM 12 volts to White wire Pin
“F” on the Accessories
connector activates the
AUX RPML
High Speed Retard #1 .1-15 Degrees/.1 degrees 12 volts to Yellow wire Pin
“D” on the Accessories
connector activates the
High Speed Retard #1
Auxiliary RPML 2 1000-12800/100 RPM 12 volts to Purple wire Pin
“E” on the Accessories
connector activates the
RPM Limit #2
Start Retard 0-10 Degrees/.1 Degrees Active only below 500 RPM
Window RPM Switch LO
Activation RPM
1000-12800/100 RPM Supplies ground to the Red
wire Pin “A” on the
Accessories connector.
Activation RPM (low end of
RPM window)
Window RPM switch HI
De-activation RPM
1100-12800/100 RPM Disables ground on the Red
wire Pin “A” on the
accessories connector. De-
activation RPM (upper end
of RPM window)
RPM Switch 2 1000-12800/100 RPM Supplies ground to the
Black wire Pin “B” on the
Accessories connector at
set RPM.
RPM Switch 3 1000-12800/100 RPM Supplies ground to the
Orange wire Pin “C” on the
Accessories connector at
set RPM.
Boost Retard .1-4 Deg/PSI of boost/.1
Degrees
Retards Timing by number
of degrees per pound of
boost. A 2 or 3 bar MAP
sensor is required.
Number of Cylinders 4,5,6,8,10,12 Set number of Cylinders
MAP Sensor 2 is 2-bar sensor, 3 is 3-
bar sensor
A MAP sensor that has a
.2-4.8 volt output for the
full range can be used.