Mallory Ignition ACCEL DIS 8 75610 - Manual (Page 4)

DIS 8
4
Installation
Read over this entire document before beginning installation!
The DIS 8 may be located inside the car or in the engine compartment. If you are
mounting the controller in the engine compartment, select a location with minimal
exposure to water as a safeguard. When mounting the unit in the inside of the car find
a well ventilated area to reduce heat created by unit. Route the wiring well away from
any moving parts or extreme heat sources like header pipes, etc. Connect the harness
as per the diagrams in this manual.
Power Input Harness
The Power to the DIS 8 module is supplied through the 4 pin connector.
Battery connection should be made directly to Battery.
Do not connect battery positive to alternator.