Little Colorado Bench Toy Box 17 - Manual (Page 2)

Quality Wooden Children’s Furniture and Accessories
Made in America • Established 1987
www . littlecolorado . com
Bench Toy Box Assembly Instructions- Continued
• Be careful not to over tighten screws.
Revised 09/09
by
W.McClung
• Insert 3 Cam Locks into the Cam Lock
holes on the right side component .
The arrow head on the face of the
Cam needs to be pointing toward the
head of the Cam Post.
• Turn the Cam 1/2 turn Clockwise
until cam stops.
Arrow Head
3
• Now that you have the two sides
fastened to the back; slide the
bottom panel in the bottom grooves
(The side with the Little Colorado
logo is the top side).
• Repeat steps 1, 2 and 3 to attach
Front panel to body
Bottom Panel
4
Page 2 of 3
• Insert Cam Posts in holes on edge
of right Side . This maybe a tight fit.
Some minor adjusting and fitting may
be needed.
2
Cam Post Holes
Partial view of Side
Cam Lock Holes
• Use a #2 Phillips head screwdriver to screw
in 4 Cam Posts to each side of Back .
• Each cam post must be fully seated and
perpendicular.
• While lid and back are laying flat on floor,
install lid support using the 4 #5 x 5/8in.
wood screws in to the pre-drilled holes.
1
Back Panel
6
Front Panel
Lid Support Detail
5
• Place the back rest into the
right side but do not install
screws. Place the left side of the
back rest into the left side slot.
Attach left side to the back following
the same procedure as 2 and 3 above.
Panel Groove
• Slide back rest to top of slot. In
stall 4 #8 x 1 5/8in. wood screws
to secure back rest.