Minuteman X17 ECO Carpet Extractor - Manual (Page 18)

18
Brush Removal
Machine Overview
• Use a 4mm or 5/32 Hex Tool to remove the flat-
head screw on the underside of the right side of
the brush housing.
• Pry open the brush housing door.
• Pull brush straight out to the side.
To re-install:
• Insert the end of the brush with drive lugs first, to
match the drive hub on the left side.
• Twist the brush until the drive hub locks in to the
brush.
• Close the brush housing door. The bearing in the
door will insert itself into the end of the brush.
• While holding the housing door closed, re-
install flat-head screw from the underside of
the housing.