Minuteman X17 ECO Carpet Extractor User Manual
Page 29
29
Troubleshooting
Circuit breaker in handle tripped.
Reset breaker.
Belt is damaged
Replace belt
Debris is lodged in the brush housing
Remove debris
Switch is in OFF (O) position
Flip switch to ON (I) position.
Dome lid filter or vac float shut off may be
clogged
Rinse out items
Recovery dome lid is not seated properly. Reposition dome lid
Recovery tank is not seated properly over
intake tube.
Reposition recovery tank so the intake
tube is inserted into the inlet.
Recovery tank dump hose may not be
closed properly.
Disconnect cap from drain hose then
reconnect, to ensure the cap and hose
snap together.
Bad seals on recovery dome lid.
Check the gasket on the lid for damage.
Replace if needed.
Vac shoe may be clogged.
Check vac shoe for debris and remove if
necessary.
Vac shoe may be worn.
Replace vac shoe.
Circuit breaker in handle may have
tripped.
Reset breaker.
Motor carbon brush may be worn.
Contact a qualified service technician.
Switch is in the OFF (O) Position
Flip the switch to the ON (I) Position
Brush does not turn ON
Vacuum motor does not start.
Solution recovery is reduced