Minuteman X17 ECO Carpet Extractor - Manual (Page 23)

23
Maintenance
USER MAINTENANCE INSTRUCTIONS
All service and repairs should be performed by a qualified service representative or electrician. No user serviceable
components are employed in the electrical assembly. No lubrication of the motor is required. BEFORE CLEANING OR
MAINTAINING THE MACHINE, UNPLUG THE ELECTICAL CORD.
Protect equipment from freezing. Severe pumping system damage can occur if allowed to freeze.
DAILY MAINTENANCE
1. Solution tank should be emptied after each use. Flush solution pump system with 1 gallon of clean, hot water.
Operate for 30 seconds through the spray jets, then drain the remaining water with the solution level/drain hose.
(Both require flushing for best performance)
2. Removable recovery tank should be rinsed clean and drained using dump hose. Tank does not need to be removed.
Wipe off any debris from O-ring under dump hose cap.
3. Dome lid should be cleaned. Pull or rinse off any debris from the attached Filter. Place lid upside-down when storing
machine, for ventilation to prevent odor build-up.
4. Vacuum shoe should be cleaned of any debris.
5. Brush should be cleaned of any carpet string or debris.
6. Vac Float Shut-off (page 12, Item P) should be pulled out, inspected, cleaned if necessary.
7. Solution In-Line Filter (page 16) should be inspected and cleaned if necessary.
8. Wheels should be cleaned of hard debris which may damage finished hard-surface floors.
9. Electrical Cord should be inspected for any damage.
10. Vacuum Hose should be inspected for tight fit at the rear of the machine, and to the bottom of the Vac Connection
Tube.