Minuteman E Ride 28_32 Rider Scrubber User Manual
Page 10
10
IMPORTANT SAFETY INSTRUCTIONS
Operators must read and understand this manual before oper-
ating or maintaining this machine.
Do not operate this machine in flammable or explosive areas.
This machine is designed solely for scrubbing dirt and dust in an
indoor environment. Minuteman does not recommend using this
machine in any other capacity.
The following information below may cause a potential hazard to the
operator and equipment. Read this manual carefully and be aware
when these conditions can exist. Take necessary steps to locate all
safety devices on the machine and train the personnel operating the
machine. Report any machine damage or faulty operation immedi-
ately. Do not use machine if it is not in proper operating condi-
tion.
FOR SAFETY DURING OPERATION
Keep hands and feet clear of moving parts while machine is in oper-
ation.
Make sure all safety devices are in place and operate properly. All
covers, doors and latches must be closed and fastened before use.
During operation, attention should be paid to other persons in the
work area and especially if small children are present.
Electric motors and components can cause an explosion when oper-
ated near explosive materials or vapor. Do not operate this machine
near flammable materials such as solvents, thinners, fuels, grain
dust, etc.
Store or park this machine on a level surface only, with the key
switch in the off position. To prevent unauthorized use, machine
should be stored or parked with the key removed.
This machine is designed for level operation only. Do not operate
on ramps or inclines.
This machine is not suitable for picking up hazardous dusts.
Use caution when moving this machine into areas that are below
freezing temperatures. Any water in the tanks or hoses can cause
damage to the machine.
FOR SAFETY WHEN SERVICING OR MAINTAINING MACHINE
Stop on level surface and turn off machine.
Disconnect the power to the machine by pressing the Red Emer-
gency Disconnect Button when charging batteries or during installa-
tion or removal of brushes.