Minuteman E Ride 28_32 Rider Scrubber - Manual (Page 26)

26
Machine Overview
1.15 Scrub Deck installation
When installing a cylindrical deck to a machine:
1. Install brushes after the deck has been mounted to avoid flat spots on the brushes.
2. Use a piece of cardboard underneath the deck to prevent scratches to the painted surface when sliding the deck under the machine.
3. Make sure the scrub deck is oriented correctly with the spray jets towards the front of the machine.
When installing a disc scrub deck to a machine:
1. Install brushes on the scrub deck; this aids the installer in sliding the deck assembly into position.
2. Make sure the scrub deck is oriented correctly with the solution hose tee fitting
towards the front of the machine.
Installation Instructions
1. Park the machine on a flat or level surface.
2. Turn the key switch to the ON position and select the transport mode with mode selector
knob.
3. Slide the scrub deck assembly underneath the machine (follow instructions as described
above)
4. Position the scrub deck to align the mounting brackets with the mounting lugs on the lift
linkage.
5. Lower the lift linkage to the floor by pressing the manual overrride switch for five seconds.
(see figure)
6. Lower the lift linkage mounting lugs until they barely touch the scrub deck mounting
brackets.
7. Fasten with (4) 711242 bolts, 711515 flat washers and 711546 lock washers.
Manual Override Switch, located
behind electrical panel.
8. For cylindrical scrub deck only:
a. Remove the yellow 3 sided knob on the side squeegee assembly and swing out the side
squeegee to reveal the access door.
b. Remove the two access doors (one on each end) by removing the three wing nuts on
each door.
c. Install the brushes by sliding them through the access opening. (see figure for correct
orientation.)
d. Align the notches on the brush with the drive pins on the hub.
e. Push the brush all the way in until it bottoms out.
f. Insert the access door hub into the other end of the brush.
g. Reinstall the wing nuts and yellow 3 sided knobs and tighten.