Minuteman E Ride 28_32 Rider Scrubber - Manual (Page 17)

17
Machine Overview
this signal is displayed, all functions will shut off, including
transport mode. The operator must then turn the key switch
OFF and then ON to reset the machine. The machine will
then have only a few minutes left of reserve power to briefly
use Vacuum Only mode to pick up any remaining solution on
the floor and Transport mode to return to the charging sta-
tion. This gauge will also display a fault code if the system
has an error. This code is represented by a specific number
of flashing LEDs. See Fault/Diagnostic Codes for specific
code information.
Solution Control Knob (E) - R2
Adjusts the amount of solution being dispensed to the floor
while in one of the scrub modes. Turn the knob clockwise to
increase the amount of solution being dispensed. The
amount of solution applied is variable to a maximum of 1
GPM.
Mode Selector Knob (F) - S4
This knob is used to select the desired operation mode of the
machine. See Operation Modes for information about each
mode.
Horn Button (G) - S3
Depressing this button will activate the machine’s horn.
Directional Switch (H) - S6
Pressing switch to the down position will set the machine to
move forward. Pressing it to the up position sets the machine
to move in reverse.