Minuteman E Ride 28_32 Rider Scrubber - Manual (Page 7)

7
The E Ride 28/32
This machine was designed with total operator comfort and ease of use in mind. All machine components have been designed as a total system
to efficiently clean dirty floors. The E Ride has four available scrub head types and sizes to fit specific applications. Please contact your Min-
uteman representative for specific recommendations for the correct scrub head type, size, and brush type and chemical applications.
Before using the machine, always perform the following steps to ensure proper machine operation.
•Check under the machine for leaks.
•Check the rear and side squeegees for wear and damage.
•Check the steering for proper operation.
•Check the solution and recovery tanks.
After using the machine, always perform the following steps:
•Check the battery charge level. Charge batteries if necessary. When charging batteries, extra precaution is required:
ƒBattery acid can cause burns.
ƒWhen working on or around batteries, always wear protective clothing and safety glasses.
ƒRemove metal jewelry. Do not lay tools or metal objects on top of the batteries.
ƒCharging batteries generate explosive gasses.
DO NOT CHARGE BATTERIES WHEN OPEN FLAMES OR SPARKS ARE PRESENT. DO NOT SMOKE.
ƒMake sure the charger is turned off before disconnecting it from the batteries.
ƒCharge the batteries in a well-ventilated area.
ƒFluid levels should be checked before and after charging and maintained at the proper levels. If low, add water until the metal plates are cov-
ered.
ƒIf the machine is not used for an extended period of time, batteries should be kept fully charged with a boost charge once a week.
•Check for wire, string, or twine wrapped around the scrub brushes.
•Check the squeegees for wear and damage.
•Check the rear squeegee suction hose and off-aisle wand hose for obstructions.
•Empty and clean the debris box (cylindrical systems only).
•Drain and clean the recovery tank.
•Check under the machine for leaks.
•Check the service records to determine maintenance requirements.
WARNING!
•Be sure you understand the machine controls and their functions.
•While on ramps or inclines, avoid sudden stops when tanks are filled.
•Avoid abrupt sharp turns. Slow down driving speed when going downhill.
•Always drive up when cleaning ramps.