Minuteman Kleen Sweep KS 32 R (6400.40) - Manual (Page 49)

49
Maintenance and Service
5.4.1 Removing the batteries
Sparking may occur when
changing the batteries! When
disconnecting, remove the
negative cable first. When con-
necting, connect the positive
cable first.
1. Switch the vehicle off using the key
switch and secure with the parking
brake.
2. Open the seat console (Fig. 17/1)
and secure with the safety support
(Fig. 17/2).
3. Disconnect the connection cables to
the batteries (Fig. 17/4).
4. Loosen the retaining strap
(Fig. 17/5).
5. Remove the batteries from the vehi-
cle using the grab handle (Fig. 17/3).
5.4.2 Inserting the batteries
Only the special, mainte-
nance-free batteries approved
by Minuteman may be installed
and at the intended position.
1. Switch the vehicle off using the key
switch and secure with the parking
brake.
2. Open the seat console (Fig. 17/1)
and secure with the safety support
(Fig. 17/2).
3. Pick up the batteries (Fig. 17/4) us-
ing the grab handle (Fig. 17/3) and
insert them in the vehicle.
4. Secure the batteries in place with the
retaining strap (Fig. 17/5).
5. Connect the batteries in accordance
with the connection diagram
(Fig. 17/6).
6. Unlock the safety support (Fig. 17/2)
and close the seat console
(Fig. 17/1).
5.4.3 Battery care
Never leave batteries in a discharged
state, always recharge them straight
away!
For more information on caring
for driving batteries, also refer
to supplementary sheet
88-60-2556 regarding "Infor-
mation on driving batteries".