Minuteman Kleen Sweep KS 32 R (6400.40) - Manual (Page 9)

9
Safety Information
• The Kleensweep KS 32 R is de-
signed for use on level ground with a
maximum gradient of 16%.
• Steps or curbs with a maximum
height of 1.5" can be driven over.
• It is forbidden to manipulate switches
and safety equipment.
1.4 Maintenance information
• The maintenance work and mainte-
nance intervals prescribed in the op-
erating manual must be adhered to.
• Operating personnel must complete
the necessary daily and weekly
maintenance work. All other mainte-
nance work must be completed at
your nearest Minuteman service
center.
• Pay attention to any rotating parts
before starting cleaning and mainte-
nance work. They represent a risk of
crushing!
• The vehicle must be inspected by a
recognized technical expert in re-
spect of operational safety, within
the terms of the applicable accident
prevention laws, at reasonable inter-
vals (we recommend at least once a
year) and following modification or
repairs.
• Spare parts must comply with the
minimum technical requirements
stipulated by the manufacturer! This
is ensured by the use of original
spare parts.
• When completing any maintenance
and repair work, switch the machine
off via the key switch to prevent the
drive being started up inadvertently.
• Suitable tools must be used for
cleaning and maintenance work.
• If the seat console must be raised to
complete work, it must be held in
place by the safety support to pre-
vent it accidentally falling or slam-
ming shut.
• It is not permitted to clean the vehicle
with a pressure washer or steam
blaster.
• The dirt hoppers must be cleaned
regularly to prevent the accumula-
tion of bacteria.
• It is not permitted to use aggressive,
corrosive cleaning agents.
• Let the machine dry thoroughly after
cleaning, e.g. over the weekend.
• When transporting the vehicle, the
vehicle must be switched off.
• If the Kleensweep KS 32 R is jacked
up with a jack, it must be properly
supported.
• No persons may be on the Kleen-
sweep KS 32 R when it is jacked or
raised.
• When changing wheels, the vehicle
must be additionally secured from
rolling away by placing wheel chocks
against the wheels.
Always change wheels on level, sol-
id ground, where possible.
• Do not remove or replace tires or re-
pair one on a rim. Always go to a
proper workshop for work on tires
and rims because they have special-
ly trained personnel and special
safety tools.
• Do not carry out any welding, drilling,
sawing or grinding work on frame
parts. Damaged parts may only be
replaced by specialist workshops ap-
proved by Minuteman.