Minuteman Kleen Sweep KS 32 R (6400.40) - Manual (Page 54)

54
Maintenance and Service
5.6.1 Cleaning the broom space
Check the broom space (Fig. 20/5) dai-
ly for soiling and clean it as necessary.
1. Switch the vehicle off using the key
switch and secure with the parking
brake.
2. Remove the dirt hoppers (Fig. 20/3)
and empty them.
3. Clean the broom space (Fig. 20/5)
and check for signs of damage.
5.6.2 Setting the sweeping pattern
The sweeping pattern must be readjust-
ed in the case of bristle wear and after
changing the cylindrical broom
(Fig. 20/7).
To control the sweeping pat-
tern, mark the floor with chalk.
1. Switch the vehicle off using the key
switch and secure with the parking
brake.
2. Open the seat console (Fig. 20/1)
and secure with the safety support.
3. Turn the adjusting bolt (Fig. 20/2)
until the cylindrical broom (Fig. 20/7)
touches the ground.
4. Unlock the safety support and close
the seat console.
5. Switch on the vehicle and allow the
cylindrical broom to rotate briefly
while at a standstill.
6. When setup correctly, the cylindrical
broom must produce a parallel
sweeping pattern of ap-
prox. 1.8“ ± 0.4“ on the floor.
7. Repeat the process, if necessary,
until the setting is correct.