MotorVac OilClean MOF-1000 - Manual (Page 12)

Before You Begin
First Time Operation
NOTE
The following is used to PRIME your new
MOTORVAC OILCLEAN-1000 SYSTEM, and is only
necessary the first time you use the unit.
NOTE
Do Not Operate Machine Below 50° Fahrenheit (10° Celsuis).
Detergent should be used / stored above 50°(10° Celsius).
1. Remove OILCLEAN-1000 from box.
2. Install new filter in unit’s filter bowl. (See page 4-4) Verify that the O’Ring is securely in place in the
plastic filter bowl
. NOTE: Hand tighten filter only. Do not over tighten.
Check the output/return hoses, battery connections, and all external components for damage .
3. Open the one-gallon container of OILCLEAN-1000 cleaner detergent included with the starter kit
(This Starter Kit supplied in USA & Canada only). Shake container, place a funnel into unit’s fill
neck and carefully pour the contents into the unit’s tank. Note: The maximum capacity of the
unit’s reservoir is 72 OUNCES.
4. Attach the unit to the vehicle's battery by connecting the red battery clip to the positive (+) battery
terminal and the black battery clip to a solid ground point as far from the battery as possible. Press
the MAIN POWER switch to on.
5. Attach the adaptor #065-1033 to red OILCLEAN-1000 hose and insert into units tank fill neck.
6. Press and hold the FILL switch until a solid stream of fluid is flowing out the RED hose adapter.
7. The MOTORVAC OILCLEAN-1000 System is now ready for service. Press unit’s MAIN POWER
switch off.
8. Proceed to Oil System Cleaning Procedures, page 4-1.