MotorVac OilClean MOF-1000 User Manual
Page 15
21. Filter Bowl Purge Procedure:
To lower oil level in the filter bowl and decrease oil spillage when replacing units filter:
•
Attach the unit to a 12 volt battery by connecting the
red
battery clip to the positive (
+
)
battery terminal and the
black
battery clip to the negative (-) battery terminal.
•
Next install open-end adaptor (#065-1033) into red hose and place into suitable container.
Press the AIR BLAST button. Allow purging into suitable container until fluid flow ends. Filter
bowl is now purged. Turn off unit and disconnect power harness from battery. Remove adaptor
from red hose. Unit is now ready for filter replacement.
EXTERNAL FILTER, REMOVE / REPLACE
NOTE: Place drain pan underneath filter bowl Turn filter bowl clockwise to remove. Remove old
filter. Install new filter (050-1925) by pushing up into filter base 050-1926. Before installing filter
bowl, verify Viton O’Ring is installed in filter bowl. Install filter bowl and turn counter clockwise to
tighten. Caution, hand tighten only.
Part number for FILTER BASE AND BOWL ASSEMBLY is 200-8611, which does include two
elbow fittings (030-4805). Note: does not include steel mounting bracket (011-0068).
FILTER ELEMENT
050-1925
FILTER BOWL 050-1007
[Viton O’Ring (Not Shown) 080-2302
Note: O’Ring fits inside bowl]
FILTER BASE (Plastic Top)
050-1926