MotorVac OilClean MOF-1000 - Manual (Page 14)

Service Procedure
Bring engine to operating temperature, and then check engine oil level. Fill or top off to vehicle
manufacturer specifications.
1. Verify new OilClean filter element is installed in unit and that the OilClean’s filter bowl
O’Ring is in place. Refer to page 4-4 showing filter installation. If unit was previously used,
see line 21 below for filter bowl purge procedure. Dispose of used filter element in
appropriate manner.
2. Remove engine’s oil filter and install correct OilClean oil filter adapter housing with insert.
(See application guide). Ensure that adapter housing O’Ring is in place.
3. Connect the OilClean hoses to oil filter adapter housing assembly (black to black, red to red).
4. Connect the unit’s power harness to the vehicle's battery by connecting the red battery clip to
the positive (+) battery terminal and connecting the black (-) battery clip to a solid ground
point as far from the battery as possible.
5. Verify the OilClean MAIN POWER switch is in the ON position.
6. Note: In cold weather its helpful to start the vehicles engine to circulate hot oil thru the hoses
and filter. Shut the engine off before proceeding .
7. Press the “DETERGENT FILL” button. Note: Select fill level depending on vehicle
crankcase capacity. Hold the button and monitor the level in the fluid tank until the correct
amount is pumped into the vehicle.
0 – 5 Quart (0 – 4.7 Liter)……….….. Use 12 to 16ounces (.47 Liter) of cleaner
6 – 10 Quart (5.7 – 9.5 Liter)……….. Use 24 to 32ounces (.95 Liter) of cleaner
8. Set CYCLE TIME (Thirty minutes maximum).
0 – 5 Quart (0 – 4.7 Liter)…….10 – 15 minute clean cycle (Recommended)
0 – 10 Quart (5.7 – 9.5 Liter)…15 – 20 minute clean cycle (Recommended)
9. (The alarm will sound until engine oil pressure is achieved). Start engine and Verify Engine
Oil Pressure Alarm should go off.
NOTE: VEHICLE MUST HAVE OIL PRESSURE BEFORE PROCEEDING.
10. When service is complete, alarm sounds. Stop engine. Turn “POWER” switch off to silence
the alarm.
11. Remove drain plug from engine oil pan and drain oil into suitable container.
12. Disconnect red hose from the OilClean filter adapter assembly. Install optional block-off cap
(#065-1055) on red adapter hose fitting or direct red hose toward drain pan.
13. Remove engine’s oil filler cap. Turn “POWER” Switch back on.
14. Press and hold the “AIR BLAST” switch. To purge any remaining oil/sludge in the engine oil
pan and to clear oil pump screen. NOTE: SHOP AIR HOSE MUST BE CONNECTED
TO UNIT FOR AIR BLAST TO WORK!
15. Press POWER to OFF position. Remove power cable from vehicle.
16. Remove black hose from OilClean adapter.
17. Remove OilClean adapter from engine.
18. Install new engine oil filter, and reinstall drain plug in oil pan.
19. Fill engine with correct amount of clean oil and reinstall oil fill cap.
20. Start engine and verify no oil leaks.
Test drive vehicle. Stop engine and do final engine oil level check.
The OilClean service is now complete.
See next page-DRAIN FILTER BOWL while the air supply hose is connected.