MotorVac OilClean MOF-1000 - Manual (Page 16)

Troubleshooting and Additional Help
Refer to the list below in the unlikely event that you have problems with your
OilClean 1000.
Problem:
Solution:
1. The OilClean is not operational or
trips breaker immediately.
Polarity is reversed on vehicle battery connection.
Check connections for correct polarity. Check
circuit breaker on front of the cabinet.
2. Units Vehicle Oil Pressure Light stays
on when Engine is started.
Output and Return hoses may be reversed. Check
hoses for correct connection.
3. Fluid does not flow from tank to
vehicle when detergent fill switch is
held on.
Engine must be OFF. (Not running).
Engine oil may be cold. (Warm up engine & cycle
warm oil thru units’ hoses & filter).
Internal screen filter may be plugged up.
Pump may need to be ‘primed’.
4. The OilClean performs poorly.
Check all hoses and wires for cuts or frays.
Check cabinet for dents or impact markings.
Verify that the oil filter was replaced.
5. Sudden pressure drop on Vehicle
Pressure Gauge.
Blockage or restriction in black hose.
ADDITIONAL HELP
Please verify that items 1- 5 above have been
reviewed before calling for additional assistance
have your model and serial numbers available:
In the unlikely event that problems persist with the
OilClean, call: Your Local Distributor
Or: MOTORVAC TECHNOLOGIES INC.
1431 S. VILLAGE WAY
SANTA ANA, CA 92705 USA
714.558.4822
800.841.8810