DoorKing 1812 Classic - Manual (Page 31)

1812-065-U-12-13 29
2.5.2 Call Forward - Enable / Disable
This programming sequence Enables/Disables the call forward feature. You must have a call forward phone number
programmed into the 1812 memory (See 2.5.1 above). Call forward can only be used when the 1812 is programmed in
phone mode (see 2.3.1). Call forward MUST be disabled if you are going to use a call forward time zone activation (2.4.5).
1. Press * 1 4 and enter the MASTER CODE. [ * 1 4 _ _ _ _ (beep)]
2. Press 0 * to disable call forward, OR press 1 * to enable call forward. [ _ * (beep)]
3. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
2.5 Programming Dial-Out Functions
2.5.1 Call Forward Phone Number Programming
These steps program the call forwarding telephone number into the 1812 memory. Call forwarding can only be used when
the 1812 is programmed in phone mode (see 2.3.1). To Enable/Disable call forward see 2.5.2 below. The call forward
phone number can also be set up for a time zone activation (2.4.5).
1. Press * 1 0 and enter the MASTER CODE. [ * 1 0 _ _ _ _ (beep)]
2. If the forwarding phone number is 11 digits:
Press 1 then enter the area code, then press * . [ 1 _ _ _ * (beep)]
If the forwarding phone number is 10 digits:
Press # then enter the area code, then press * . [ # _ _ _ * (beep)]
If the forwarding phone number is 7 digits:
Press # # # #, then press * . [ # # # # * (beep)]
3. Enter the seven-digit phone number, then press * . [ _ _ _ _ _ _ _ * (beep)]
Note: 7 digits, no dashes.
4. Press 0 # TOGETHER to end. [0 # (beeeeeep)]
2.5.3 Preprogrammed Phone Numbers “Dial a Phone Number”
The 1812 has the capability of operating as an auto-dialer system and can store up to 3 phone numbers in its memory.
When a visitor enters a “Directory number” 01, 02, or 03 on the system keypad, the 1812 will call the preprogrammed
phone number programmed for that specific directory number. This feature can only be used when the 1812 is
programmed in phone mode (see 2.3.1).
Note: These phone numbers function differently than the call forward phone number that was programmed in 2.5.1.
To program the phone number that will be called when “01” is pressed on the system keypad:
Note:
Press
* 2 2 in step 1 to program the phone number called when “02” is pressed on the system keypad.
Press * 2 3 in step 1 to program the phone number called when “03” is pressed on the system keypad.
1. Press * 2 1 (See note below) and enter the MASTER CODE. [ * 2 1 _ _ _ _ (beep)]
2. If the phone number is 11 digits:
Press 1 then enter the area code, then press * . [ 1 _ _ _ * (beep)]
If the phone number is 10 digits:
Press # then enter the area code, then press * . [ # _ _ _ * (beep)]
If the phone number is 7 digits:
Press # # # #, then press * . [ # # # # * (beep)]
3. Enter the seven-digit phone number, then press * . [ _ _ _ _ _ _ _ * (beep)]
Note: 7 digits, no dashes.
4. Press 0 # TOGETHER to end. [0 # (beeeeeep)]