DoorKing 1816 Intercom System-Multi - Manual (Page 30)

3.2.2 Turning Programmable Directory Codes On / Off
The programmable directory codes can be turned "ON" or "OFF" after they have been programmed.
It will be necessary to turn this feature off if any trouble shooting of the system is ever required.
Turning the programmable directory code feature off does not cause the system to erase any
directory codes that have been previously programmed.
Factory Default = 1 (Off)
1. Take the doorman telephone off hook.
2. Press *13 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. Press 1 to turn this feature OFF; or press 0 to turn this feature ON then press * (beep).
(1 = system will use system relay number for resident identification. 0 = each resident
will be assigned a directory code.)
4. Hang up the doorman telephone to end the programming session.
3.2.3 Directory Code for Doorman/Concierge to Lobby Panel
This programmed directory code is used to initiate calls from the lobby panel directly to the
doorman/concierge phone and vise-versa. Code must be between 4000 and 9999. Be sure that you
do not duplicate outside line access codes (see section 3.3).
Factory Default = (Not Programmed)
1. Take the doorman telephone off hook.
2. Press *18 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. Enter a four-digit code (4000 – 9999) _ _ _ _ then press * (beep).
4. Hang up the doorman telephone to end the programming session.
3.2.4 Erasing All Programmed Directory Codes
This programming sequence will erase ALL programmed directory codes from the system. Caution –
this programming sequence is irreversible once it is started.
1. Take the doorman telephone off hook.
2. Press *15 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. Enter 9 9 9 9 then press * (beep).
4. Hang up the doorman telephone to end the programming session.
Page 30 1816-065-K-12-11