DoorKing 1816 Intercom System-Multi - Manual (Page 37)

3.6.3 Program Call Forward Numbers
This programming sequence is used by the doorman or system administrator to program call forward
numbers for residents. If option 3 was selected in 3.6.1, then the area code will be checked to see if
it is allowable or not. If not allowed, the system will ring the resident’s phone.
Note: If programmable directory codes are used, enter the directory code number instead of
the relay number in step 3.
Factory Default = (Not Programmed)
1. Take the doorman telephone off hook.
2. Press *40 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. Enter the four-digit relay number of the resident that call forward number is being
programmed for _ _ _ _ then press * (beep).
4. Enter the call forward phone number (1 to 12 digits) then press * (beep).
5. Repeat steps 3 and 4 to program additional resident call forward numbers.
6. Hang up the doorman telephone to end the programming session.
3.6.4 Delete Call Forward Numbers
This programming sequence is used by the doorman or system administrator to delete call forward
numbers for residents.
Note: If programmable directory codes are used, enter the directory code number instead of
the relay number in step 3.
Factory Default = (Not Programmed)
1. Take the doorman telephone off hook.
2. Press *49 and enter the four-digit MASTER CODE _ _ _ _ (beep).
3. Enter the four-digit relay number of the resident that call forward number is being deleted
for _ _ _ _ then press * (beep). Note: entering 9 9 9 9 in this step will delete call
forwarding numbers for all residents.
4. Hang up the doorman telephone to end the programming session.
1816-065-K-12-11 Page 37