DoorKing 2348 Elevator Control - Manual (Page 28)

Page 28 2348-065-E-10-11
5.2 Software Programming
When setting up the Remote Account Manager Software (refer to manual 1835-066), there are some
programming steps that must be made in order for the elevator control functions to operate properly:
• On 1830 series phones - In the System Information Screen, make sure the selection is
made for “1833/1835/1837/1838”.
• If tracker expansion boards are required - To support the reader device inside the elevator
car, check the tracker box in the System Information screen.
• Security Level 02 or higher - You must program security levels for building tenants and
residents. The default security level 01 does not provide any elevator control for
building tenants! For 24-hour access to floors you must program a security level for 24 hr,
7 day access and click on all used floor locations.
• Select Relay and Floor(s) - Within the Security Level, you must select the relay (card
reader) that is inside the elevator, and any floors that the users will be allowed to access.
• Relay / Elevator - You must identify which system reader is inside which elevator car. This
is performed in the Relay/Elevator screen.
• Elevator Reference Number - In Resident Screen, this tells which elevator will respond a
specific tenant when they grant access to a visitor.
The following pages show these various screens and provide some quick reference information on
setting up and programming the Remote Account Manager Software for elevator control functions.
For further details, please refer to the Remote Account Manager Software manual (1835-066).