DoorKing 2348 Elevator Control - Manual (Page 9)

1.3 Resident Elevator Control
When elevator control is in use, an access device such as a card reader must be installed in the
elevator car to allow residents access to the floors in the building. Residents can be restricted to
certain floors, or allowed access to all floors. These restrictions are dependent on the security level
assigned to the resident and are programmed in the DoorKing Remote Account Manager software.
When a resident enters the elevator car, they insert their access card into the card reader. This is
necessary because the floor buttons in the elevator remain "dead" until a command is received by the
2348-010 board to turn them on. Depending on the security level assigned to them, the floor
button(s) in the elevator car will become "live.”
The time interval that the button(s) is “live” is dependant on the revision level of the 1830 series
telephone entry/access controller circuit board, not the 2348 elevator control board. Refer to the
table below.
Controller Circuit Board Revision Level Time Interval
1833
1835 A - E
1837
7 Seconds
1833
1835 F - Higher
1837
Programmable from 1 to 254
seconds
1838 A - C 7 Seconds
1838 D - Higher
Programmable from 1 to 254
seconds
Table 1
1.3.1 Programming Resident Floor Control Relay Time
The following programming sequence can only be performed at the telephone entry / access system
controller keypad. The resident elevator button relay time interval cannot be programmed via the
Remote Account Manager software. The maximum time that can be entered is 254 seconds.
Factory setting = 007
1. Press * 3 6 and then enter the four digit master code _ _ _ _ (beep). The display on the
1835 and 1837 systems will read: RES ELE TIME xxx SEC
2. Enter the relay time in seconds (001 – 254) _ _ _ then press * (beep).
3. Press 0 # together to end this programming sequence (beeeeeep).
2348-065-E-10-11 Page 9