Nova-Tech IHS 2a - Manual (Page 16)

1) To set this parameter press the [Mode] key during self‐checking test when
turning on the balance.
2) After a few seconds, the display will show the first function F1 UNT.
3) Press the [Mode] key to select F2 EL .
4) Press the [Tare] key to view the current settings for the backlight.
5) To change the settings press the [Mode] key to scroll through other settings
as shown above.
6) Press [Tare] to store a particular setting. The display will return to F2 EL
7) When F2 EL is displayed press the [Print] key to return to weighing or press
[Mode] to go to the next function.
6.3 SETTING THE PRINTING PARAMETERS / ACCUMULATION
1) To set this parameter press the [Mode] key during self‐checking test when
turning on the balance.
2) After a few seconds, the display will show the first function F1 UNT.
3) Keep pressing the [Mode] key until F3 SEr is displayed.
4) Press the [Tare] key to view the current settings.
5) First select which communication port you wish to configure and set (only one
port can be used at a time).
The screen will show S 232 or S USb. Press the [Mode] key to select which
interface you would like to use. Press [Tare] to confirm setting and configure
interface.
6) The following options are available for setting the output and accumulation
functions:
Mode Print Feature Accumulation
P1 Prt
Data is sent whenever the [Print] key is
pressed. Manual accumulation when
the [Print] key is pressed.
P2 Con
Data is sent continuously. Accumulation is disabled.
P3 AUT
The weighing results will be sent to the
communication port automatically Automatic accumulation when
stable
16 | P a g e © Adam Equipment Company 2008