Pach and Company AeGIS 7000P Series Manual - Manual (Page 14)

AeGIS 7000P Page 14
II. Keypad Function and Layout
III. Programming Function Codes
FUNCTION CODE PROGRAMMING
00
MASTER CODE (0000 is default)
Change the master code for your security
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13
1. Enter function code 00 then press #
2. Enter new 4-digit master code then press #
01
ADDING NEW TENANT DIRECTORY
Each tenant must have unique directory. Directory
can be set 2-4 digit. See function code 06, p17
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13
1. Enter function code 01 then press #
2. Enter 2, 3 or 4 digit directory depending on
function code 09 setting, then pres #
MASTER CODE: 0000
Enter Dir: _ _ _
NOTE: DO NOT START DIRECTORY WITH 00,
000, or 0000