Pach and Company AeGIS 7000P Series Manual - Manual (Page 17)

AeGIS 7000P Page 17
press #
07
SINGLE OR MULTI SYSTEM
1= Single 0= Multi
Default is single
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13
1. Enter function code 07 then press #
2. Select 1 or 0 then press #
08
SYSTEM ID
Not applicable
Not Applicable
10
WELCOME MESSAGE
Welcome message is up to
48-characters and divided into
3- segments and 16-characters for each
segment
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13
1. Enter function code 10 then press #
1 st segment
2. Change the welcome screen, , see (Keypad
Function and Layout page 14).
3. Press # after entering the last letter on 1
st
segment
2 nd segment
4. Press # after entering the last letter on 2 nd
segment
3 rd segment
5. Press # after entering the last letter on 3 rd
segment.
40
MASTER CODE MASK
0= Unmask
1=Mask
Default is Unmasked
Must be in programming mode, see Two ways to
Log-on to programming mode: on page 13
1. Enter function code 40 then press #
Wait …..
WARNING: CHANGING THE DIRECTORY DIGIT
WILL ERASE ALL TENANT DIRECTORY
NOTE: SET TO MULTI IF MORE THAN ONE SYSTEM
SHARING ONE PHONE LINE
SING=1, MULT=0: 1
Welcome to Pach’
s Telephone Acce
ss System …
**