PASCO SE-7183 Spectrometer - Manual (Page 3)

1
Introduction
This manual contains instructions for using the SPARK Science Learning
System or SPARKvue software with an Ocean Optics spectrometer, such as the
Amadeus Spectrometer and the Red Tide Spectrometer.
With the combination of these devices and software, you can monitor and
record a spectrum or continuously record light intensity in a defined
wavelength band. You can use the spectrometer to analyze light from sources
such as the sun or a fluorescent lamp, or you can use it with the included light
source and cuvette holder to analyze light transmitted through a solution.
In addition to light intensity, SPARK Science Learning System or SPARKvue
software calculates absorbance, transmission and relative irradiance.
These instructions assume that you are familiar with the general use of SPARK
Science Learning System or SPARKvue software. For complete instructions on
using SPARK, see the SPARK User’s Guide.
For more information about the hardware and theory of operation of your
spectrometer, see the user’s guide included with the spectrometer.
Ocean Optics Spectrometers require the SPARK version 1.2.0. If you are running
an older version, visit www.pasco.com to download the most recent version of
SPARK firmware or SPARKvue software
Connecting the spectrometer
1. Use the USB cable included with the spectrometer to connect the
spectrometer to the SPARK Science Learning System or to a computer
running SPARKvue software.