Setting the sampling rate, Collecting data, About the spectrometer properties – PASCO SE-7183 Spectrometer User Manual
Page 7
5
S
ETTING
THE
S
AMPLING
R
ATE
16.
After you have finished editing the spectrometer properties, return to
your SPARKlab:
a.
Select OK to close the Spectrometer Properties screen.
b.
Select Done to close the Sensor Configuration screen.
c.
Select OK to close the Experiment Tools screen.
Setting the Sampling Rate
1.
From any SPARKlab page, select the Sampling Options button to open
the Sampling Options screen.
2.
Select the box next to Sample Rate: and select the desired sample rate.
3.
Select OK to return to the SPARKlab.
Collecting Data
1.
Select the Start button to start recording data.
2.
Select the Stop button to stop recording data.
About the spectrometer properties
Use this information to help determine which properties you need to set for
your application, and what value to select for each property.
See “Editing the spectrometer properties” above for instructions on setting the
properties.