PASCO ME-8744 ADJUSTABLE ANGLE ROD CLAMP User Manual

Adjustable angle rod clamp, Instruction sheet for the pasco model me-8744

Advertising
background image

Instruction Sheet
for the PASCO
Model ME-8744

ADJUSTABLE ANGLE ROD CLAMP

012-06111A

3/96

$1.00

better

teach science

ways to

Phone (916) 786-3800 • FAX (916) 786-8905 • email: [email protected]

10101 Foothills Blvd. • P.O. Box 619011 • Roseville, CA 95678-9011 USA

®

© 1996 PASCO scientific
This instruction sheet written/edited by: Robert Morrison

Introduction

The Adjustable Angle Rod Clamp is designed to allow
users flexibility in their lab set up.

Equipment

– Adjustable Angle Rod Clamp assembly.

Additional equipment recommended:

– PASCO ME-8735 Large Rod Stand

– PASCO ME-8738 90 cm Support Rod

Assembly

To use the Adjustable Angle Rod Clamp:

➀

Attach the “fixed” rod clamp, with the locking knob
permanently affixed, to a base rod up to 1/2” (12.5
mm) in diameter. See Figure 1.

➁

Secure the rod clamp in place with the thumbscrew.

➂

Loosen the locking knob and rotate the “mobile” rod
clamp into the desired position. See Figure 2.

➃

Tighten the locking knob against the mobile rod
clamp until secure.

➄

Place additional rod or equipment in the mobile rod
clamp and secure with the thumbscrew.

ME-8735 Large Rod Stand

(not included)

Figure 1: Setting Up the ME-8744

Adjustable Angle Rod Clamp

support rod

thumbscrew

“fixed” rod

clamp

“mobile” rod clamp

locking knob

“fixed” rod clamp

ME-8744 Adjustable

Angle Rod Clamp

Advertising