PASCO ME-8744 ADJUSTABLE ANGLE ROD CLAMP - Manual (Page 2)

2
Rotating Rod Clamp 012-06111A
®
Limited Warranty
PASCO scientific warrants this product to be free from
defects in materials and workmanship for a period of one
year from the date of shipment to the customer. PASCO
will repair or replace, at its option, any part of the product
which is deemed to be defective in material or workman-
ship. This warranty does not cover damage to the product
caused by abuse or improper use. Determination of
whether a product failure is the result of a manufacturing
defect or improper use by the customer shall be made
solely by PASCO scientific. Responsibility for the return
of equipment for warranty repair belongs to the customer.
Equipment must be properly packed to prevent damage
and shipped postage or freight prepaid. (Damage caused
by improper packing of the equipment for return ship-
ment will not be covered by the warranty.) Shipping costs
for returning the equipment, after repair, will be paid by
PASCO scientific.
Equipment Return
Should this product have to be returned to PASCO scien-
tific, for whatever reason, notify PASCO scientific by let-
ter or phone BEFORE returning the product. Upon notifi-
cation, the return authorization and shipping instructions
will be promptly issued.
➤ NOTE:
NO EQUIPMENT WILL BE ACCEPTED FOR
RETURN WITHOUT AN AUTHORIZATION.
When returning equipment for repair, the units must be
packed properly. Carriers will not accept responsibility
for damage caused by improper packing. To be certain
the unit will not be damaged in shipment, observe the fol-
lowing rules:
➀ The carton must be strong enough for the item
shipped.
➁ Make certain there is at least two inches of packing
material between any point on the apparatus and the
inside walls of the carton.
➂
Make certain that the packing material cannot shift in
the box, or become compressed, thus letting the instru-
ment come in contact with the edge of the box.
“mobile” rod
clamp
“fixed” rod
clamp
thumbscrew
thumbscrew
support rod
locking knob
Figure 2: Adjustable Angle Rod Clamp Adjustment
Alternate use:
➀ Follow steps one and two above.
➁
Loosen the locking knob, and remove the mobile rod
clamp.
➂
Replace the mobile rod clamp with a piece of equip-
ment that has a 1/4 - 20 thread. See Figure 3.
➃
Rotate the equipment to the correct orientation then
secure it with the locking knob.
CI-6 538 RO TAR Y M OTION SENSO
R
“mobile” rod
clamp
“fixed” rod clamp
locking knob
applicable equipment
(PASCO CI-6538 Rotary Motion
Sensor shown, not included)
Figure 3: Alternate Use for the
Adjustable Angle Rod Clamp