Experiment 10: transistors, Ab c d – PASCO EM-8622 BASIC ELECTRICITY User Manual

Page 31

Advertising
background image

27

012-04367E

Basic Electricity

EQUIPMENT NEEDED:

-Circuits Experiment Board

-Two D-cell Batteries

-Wire Leads

-Digital Multimeter (DMM)

-1000-

Ω

Resistor

-2N3904 Transistor (NPN)

-100-

Ω

Resistor.

Purpose

The purpose of this lab will be to experimentally determine some of the operating characteristics
of a transistor.

Procedure

➀

Connect the circuit shown in Figure 10.1a using the 2N3904 Transistor you’ve been supplied.
Resistor R

1

= 1000

Ω

and resistor R

2

= 100

Ω

. Use Figure 10.1b as a reference along with Figure

10.1a as you record your data. Note the leads on the transistor as marked next to the socket in the
drawing.

➁

Adjust the potentiometer carefully until the reading between points A and B is approximately
0.002 volt (2.0 mv). Now read the voltage between points C and D. Record these readings in
your data table. Note that V

AB

divided by R

1

gives the current flowing to the base of the transis-

tor, while V

CD

divided by R

2

gives the current flowing in the collector part of the circuit.

➂

Adjust the potentiometer to give V

AB

the following readings, each time reading and recording the

corresponding V

CD

: 0.006, 0.010, 0.015, 0.020, 0.025, 0.030, 0.035, 0.040, 0.045, 0.050, 0.055,

0.060, 0.080, 0.100, 0.150, 0.200, 0.250 volts. Also set V

AB

to 0.000 volts.

Experiment 10: Transistors

Figure 10.1a

Figure 10.1b

A

B

C

D

b

c

e

e

b

c

Transistor as seen from
above

Socket

2N3904

A

R

1

B

C

2N3904

D

R

2

c

e

b

R

2

R

1

Advertising