Before using for the first time – Bosch TES50159DE VeroCafe Kaffeevollautomat schwarz User Manual

Page 28

Advertising
background image

Robert Bosch Hausgeräte GmbH

24

en

“Coffee strength” rotary knob

This rotary knob (13) is used

to adjust the coffee strength

or select the setting for

pre­ground coffee.

h

to

g

G

Very mild

Mild

Medium

Strong

Ground coffee

“Drink selection” rotary knob

This rotary knob (14) is

used to select the required

beverage and quantity. It is

also used to change user

settings.

a

to

c

Small espresso

Espresso

Small café crème

Café crème

Large café crème

b

to

d

2 small espresso

2 espresso

2 small café crèmes

2 café crèmes

2 large café crèmes

Milk frother

Pull the milk frother (6) out to open it and

push it back in to close it.

Before using for

the first time

General

Fill the appropriate container using only

pure, cold, uncarbonated water and only

roasted beans (preferably espresso or

coffee bean blends for fully automatic coffee

machines). Do not use coffee beans that

have been glazed, caramelised or treated

with other additives containing sugar, since

they will block the brewing unit.

The water hardness setting can be adjusted

on this appliance. The factory setting for the

water hardness is 4. Check the hardness

of the water you use with the enclosed

test strip. If the test reveals a value other

than 4, change the setting on the appliance

accordingly after switching on (see

“Settings” – “Water hardness”).

Setting up the appliance

1. Remove the protective film.

2. Place the fully automatic espresso

machine on a flat, water­resistant

surface that can take its weight. The

venti lation slots on the appliance must

not be covered.

Important: Only use the appliance in

frost­free rooms. If the appliance has been

transported or stored at temperatures below

0 °C, wait at least 3 hours before operation.

3. Pull out the mains plug from the cable

compartment (20) and plug it in. Adjust

the length of the cable by pushing it

back in and pulling it out. To do this,

place the appliance with its back flush

with the edge of the work surface and

either pull the cable

downwards or

push it

upwards.

Advertising