Bosch TES50159DE VeroCafe Kaffeevollautomat schwarz User Manual
Page 31
27
TES501.. | 02/2014
en
If you wish to change the default degree
of water hardness, or if you have inserted
a water filter, proceed as follows:
1. Turn the rotary
knob (13) to position
2. Press and hold buttons
B
(11) and
A
(12) simultaneously for at least
5 seconds. The set water hardness is
indicated by the number of LEDs that
now light up.
3. Now press the start button (10) repeat
edly until the required water hardness
is indicated, e. g., for water hardness 3,
LEDs
D
,
E
and
F
will light up.
4. Press and hold the start button (10)
for at least 5 seconds. The set number
of LEDs will light up to indicate that
the selected water hardness has been
saved successfully.
Important: If a water filter is used (see
“Accessories”), proceed as follows, see
“Water filter”.
Note: If no button is pressed within
90 seconds, the appliance switches to
standby mode without saving the new
settings. In this case, the previously saved
water hardness setting is retained.
Automatic switch-off
Here you can set the period of time after
which the appliance should switch off auto
matically following the last drink preparation.
A time between 15 minutes and 4 hours can
be set. To save power you can specify a
shorter period.
1. Turn the rotary
knob (13) to position
2. Press and hold buttons
B
(11) and
A
(12) simultaneously for at least 5 seconds.
The time after which the appliance
should switch off is indicated by the
number of LEDs that now light up.
3. Now press the start button (10) repeatedly
until the required number of LEDs light
up to indicate the switchoff time:
D
= 15 minutes
D
and
E
= 30 minutes
D
,
E
and
F
= 45 minutes
D
,
E
,
F
and
G
= 1 hour
D
,
E
,
F
,
G
and
H
= 2 hours
D
,
E
,
F
,
G
,
H
and
I
= 4 hours
4. Press and hold the start button (10) for
at least 5 seconds. The set number of
LEDs will light up to indicate that the
selected switchoff time has been saved
successfully.
Note: If no button is pressed within
90 seconds, the appliance switches to
standby mode without saving the new
settings. In this case, the previously saved
switchoff time is retained.
Setting the brewing temperature
The brewing temperature can also be set.
1. Turn the rotary
knob (13) to position
2. Press and hold buttons
B
(11) and
A
(12) for at least 5 seconds. The set
brewing temperature is indicated by the
number of LEDs that now light up.
3. Now press the start button (10) repeatedly
until the required number of LEDs light
up to indicate the temperature:
LED
D
= low
LED
D
and
E
= medium
LED
D
,
E
and
F
= high
4. Press and hold the start button (10) for
at least 5 seconds. The set number of
LEDs will light up to indicate that the
selected temperature has been saved
successfully.
Note: If no button is pressed within
90 seconds, the appliance switches to
standby mode without saving the new
settings. In this case, the previously saved
brewing temperature setting is retained.